Getting started_ 24
2.getting started
This chapter gives you step-by-step instructions for setting up the USB connected machine and software.
This chapter includes:
• Setting up the hardware
• Printing a report
• Supplied software
• System requirements
• Installing USB connected machine’s driver
• Sharing your machine locally
SETTING UP THE HARDWARE
This section shows the steps to set up the hardware, as is explained in the
Quick Installation Guide. Make sure you read the Quick Installation Guide
first and follow the steps below:
Location
1. Select a stable location.
Select a level, stable place with adequate sp
ace for air circulation. Allow
extra space for opening cover(s) and tray(s).
The area should be well ventilated and away from direct sunlight or
sources of
heat, cold, and humidity. Do not set the machine close to the
edge of your desk or table.
Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the
altitude setting to optimize your printing (See "Altitude adjustment" on
page 46).
Place the machine on a flat, stable surface so th
at there is no incline
greater than 2 mm (0.08 inch). Otherwise, printing quality may be
affected.
2. Unpack the machine and check all the enclosed items.
3. Remove tape
holding the machine securely.
4. In
stall the toner cartridge.
5. Loa
d paper (See "Loading originals" on page 48).
6. Make
sure that all cables are connected to the machine.
7. T
urn the machine on (See "Turning on the machine" on page 23).
This machine will not operate when the power main fails.
PRINTING A REPORT
Print a configuration or supplies information page to make sure that the
machine is operating properly.
To print a configuration report
In the ready mode, press and hold Stop/Clear button on the control
panel for long enough (about two seconds) until the Status LED blinks
slowly, and release.
For SCX-3205W(K), you can print a network configuration report (See
"Printing a network configuration report" on page 30).
To print a supplies information report
In the ready mode, press and hold Stop/Clear button on the control
panel for about six seconds until the Status LED lights on, and release.
SUPPLIED SOFTWARE
After you have set up your machine and connected it to your computer, you
must install the printer software. If you
are a Windows or Macintosh OS
user, install the software from the supplied CD and if you are a Linux OS
user, download the software from the Samsung website
(www.samsung.com/printer) and install.
Machine software is occasionally updated for reasons like the release
of new operating system
and etc. If needed, download the latest
version from the Samsung website (w
ww.samsung.com/printer).
To Next Page
Loading...
