Samsung SCX-4216F - Page 51

5-11
Samsung Electronics
Disassembly and Reassembly
Service Manual
5-8 Middle Cover & Exit Roller
1. Before you remove the Exit Roller, you should
remove:
- Rear Cover (see page 5-2)
- Front Cover Ass’y (see page 5-4)
- Side Cover (LH, RH) (see page 5-3)
- Scanner Ass’y (see page 5-5)
2. Remove the six screws securing the Top Cover and
remove it.
3. Unlatch the Top Cover Securing the Frame Ass'y,
using a proper tool as shown below. Then lift the Top
Cover out.
4. Remove the two screws securing the Rear-Upper
Cover, as shown below
.5. Remove the Exit Gear and Bearing, as shown below.
Exit Gear
1
Bearing
Exit Roller
2
Top Cover