5-14
Disassembly and Reassembly
Samsung Electronics
Service Manual
5-11 SMPS
1. Before you remove the SMPS, you should remove:
- Rear Cover (see page 5-2)
- Side Cover(LH, RH) (see page 5-3)
- Scanner Ass’y (see page 5-5)
- Engine Shield Ass’y(see page 5-12)
2. Remove the three screws securing the Inlet Bracket
and remove it
2. Unplug the one connector and remove the one screw
securing the Engine Shield.
4. Remove the three screws securing the SMPS. Then
lift the SMPS out, as shown below.
To Next Page
Loading...
