14_ connecting with other device
connecting with other device
Name Description
Camera Fitting
Groove
Groove that is used to fit the camera bracket.
There are two grooves; one on the top and one on the bottom.
IR LED These infrared LED's are controlled by the illumination sensor.
Lens Focal length of 3.8mm enables you to cover relatively longer range of monitoring.
Illumination Sensor Detects incoming light to control the IR LED.
DVR Connection
Cable
Connect the cable directly to the DVR without using a particular power cable.
You can use the
RJ-45 cable to connect to a remote camera.
RJ-45 Cable
Installing the camera (SEB-1005R)
The camera can be installed on the wall, ceiling, shelf or a desired position using the provided bracket.
1. Select a position where you want to install the camera.
Make sure the selected position can sustain the weight of the camera.
2. Use the screw bolts (M4 X L15) to mount the camera bracket onto
the wall or ceiling.
3. Place the camera on the selected position and fit the hole either on
the top or the bottom of the camera into the fixing bolt of the
bracket, and turn the camera clockwise.
J
You should be careful when installing the BOX camera outdoors because
the cable connectors may be wet with moisture or pile up with impurities.
CVBS+ 12V
CVBS-
N.C
GND 12V
GND(AUDIO)
GND
M4 X L15 sized
screws
wall or ceiling
To Next Page
Loading...
