Advanced Features
NOTE
" Connect the Optical cable between the DIGITAL AUDIO OUT (OPTICAL} jack on your TV and the Digital Audio Input
on the Home Theater.
* When following the connection above, the Optical jack only outputs 2 channel audio, You will only hear sound from
the Home Theater's Front, Left and Right speakers and the subwoofer. Ifyou want to hear 5.1 channel audio, connect
the D_G_TALAUDIO OUT (OPTICAL) jack on the DVD / Satellite Box (i.e. Anynet Device 1 or 2) directly to the
Amplifier or Home Theater, not the TV.
* You can connect only one Home Theater.
* You can connect an Anynet+ device using the HDMI cable. Some HDMI cables may not support Anynet+ functions.
* Anynet+ works when the AV device supporting Anynet+ is in the standby or on status.
* Anynet+ supports up to 12 AV devices in total. Note that you can connect up to 3 devices of the same type.
Anynet+ Menu
The Anynet+ menu changes depending on the type and status of the Anynet+ devices connected to the TV.
View IV Changes Anynet+ mode to TV broadcast mode.
Device List Shows the Anynet+ device list.
(devicename) MENU Shows the connected device menus. E,g. If a DVD recorder is connected, the disc menu of
the DVD recorder will appear,
(devicename) INFO Shows the play menu of the connected device. E,g. If a DVD recorder is connected, the
play menu of the DVD recorder will appear.
Recording: (*recorder) Starts recording immediately using the recorder, (This is only available for devices that
support the recording function.)
Stop Recording: (*recorder) Stops recording.
Receiver Sound is played through the receiver.
If more than one recording device is connected, they are displayed as (*recorder) and if only one recording device is
connected, it will be represented as (*devicename),
Setting Up Anynet+
(_ MENU ITTI--_ Application _ Anynet+ (HDMm-CEC)--_ ENTER[_
Ill Setup
Anynet+ (HDMm-CEC)(Off / On): To use the Anynet+ Function, Anynet+ (HDMm-CEC) must be set to On.
When the Anynet+ (HDMm-CEC) function is disabled, all the Anynet+ related operations are deactivated.
Auto Turn Off (No / Yes): Setting an Anynet+ Device to turn off automatically when the TV is turned off.
The active source on the TV must be set to TV to use the Anynet+ function.
Even if an external device is still recording, it may turn off.
!
1.
2,
Switching between Anynet+ Devices
Anynet+ devices connected to the TV are listed.
Ifyou cannot find a device you want, press the Red button to refresh the list.
Select a device and press the ENTERE_ button, You can switch to the selected device,
Only when you set Anynet+ (HDMI-CEC) to On in the Application menu, the Device List menu appears.
* Switching to the selected device may take up to 2 minutes. You cannot cancel the operation during the switching
operation.
* Ifyou have selected external input mode by pressing the SOURCE button, you cannot use the Anynet+ function.
Make sure to switch to an Anynet+ device by using the Device List,
0 English
To Next Page
Loading...
