Other Information
_il_i_i_iii_iii_i_ii_iii!!i_iii_iiiiii!iHi!iiiii!iii!_iii!_i_i!i}iii_iii_iiiiiii!_ii@i_iiiiii!iiii_iHi!Hi:_i@_ii_!_i_i_i_i_iiii_i!!_!_ii
PlasmaTV is making humming noise. • Plasma TVs typically make a soft humming sound. This b normal. It'scaused by the ebctrbal charges
that are usedto create the images on the screen.
• Ifthe humming sound b loud,you may haveset the bnghtness on the TVtoo high. Trysetting the
brightness lower.
• You can also have loud humming if the back of your Plasma TV is too close to a wall or other hard
surface.Also try rerouting your connection cables.
• Improper installationof wall mount can create excessivenobe.
Image Retention (Burn In)bsue. • To minimize the possiUlity of screen burn, this unit b equipped with screen burn reduction technology.
PixelShift technology enables you to setpicture movement up/down (VerticalLine)and side to side
(HorizontalDot).
The cable/set top box remote control • Programthe Cable/Set remote control to operate the T_ Refer to the Cable/Set user manual forthe
doesn't turn the TV on or off, or adjust the SAMSUNGTV code.
volume.
Caption on TV menu isgreyed out, • Caption can not be selected in the TV menu when connected via HDMIor Component (p. 24).
• Caption must be activated on the external device (p. 23).
A "Mode Not Supported" message • Check the supported resolution of the T_, and adjust the external device's output resolution
appears, accordingly. Referto the resolution settings on page 9 of this manual.
There isa plasticsmell from the T_ • This smell is normal and will dissipate over time.
TheTV Signal Information isunavailabb • This function is only availablewith digital channels from an Antenna / RF/Coax connection (p.26).
in the Self DiagnosticTest menu.
TheTV is tilted to the side. • Removethe basestand from the TV and reassembleit.
The channelmenu is greyed out • The Channel menu isonly availablewhen the TV source is selected.
(unavailable).
Your settings are lost after 30 minutesor • Ifthe TV is in the Store Demo mode, it will reset audio and picture settings every 30 minutes. Change
every time the TV is turned off. the settings from Store Dereo mode to Home Use mode in the Plug & Play procedure. Press the
SOURCE button to select TV mode, and go to MENU _ Setup _ Plug & Play _ ENTER_ (p.8).
You haveintermittent loss of audio or • Check the cable connections and reconnect them.
video. • Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the cables are
flexible enough for long term use. If mounting the TV to a wall,we recommend using cables with 90
degree connectors.
You see small particles when you look • This is part of the product's design and is not a defect.
closely atthe edge ofthe frame of the T_
The PIP menu is not availabb. • PIP functionality is onlyavailablewhen you are using a HDMI, PC or Component source.
POP (TV's internal banner ad) appears on • Select Home Use under Plug & Play mode. For details, referto Plug & Play Feature (p. 8).
the screen.
Some of above pictures and functions are available at specific models only.
0 English
To Next Page
Loading...
