2-4
English
5. Disconnect the power supply cable and the signal cable (IDE cable) from the current HDD. Push the
bracket to the arrow direction as in the picture below and lift it up from the bottom.
6. Use the four screws provided (SCREW-SPECIAL: PWH,+,-,6-32UNC,L14.7(4.2),ZPC) to fix the old HDD
and the additional with the bracket
(Make sure you fasten the screws firmly so that they are not loose from vibration).
SHR-1040/SHR-1040K-ENG 2006.4.4 11:12 AM ˘ ` 2-4
To Next Page
Loading...
