SHR-1040/1040K USER’S MANUAL
2-5
English
7. Mount the HDD-fixed bracket to its original position. (Installation is done in the reverse order of the disas-
sembly. Fit the bracket (BRACKET-HDD) into the bottom hole and fix the screw).
8. When done (make sure the bracket is firmly fixed), connect the power supply cable and the signal cable
(IDE) to both the old and the additional HDD (see the picture below).
9. Check if all the connections (connectors) are properly made and firmly fixed, and close the cover.
SHR-1040/SHR-1040K-ENG 2006.4.4 11:12 AM ˘ ` 2-5
To Next Page
Loading...
