EnglishEnglishEnglish
3-4
After positioning the monitor and installing four cameras in the desired location, please
connect the CAMERA to the DVR using the CAMERA CABLE (MCB-60) as shown
in the figure below.
Connection status checking method :
• Turn on the DVR after connecting cameras, and check if camera image is displayed.
• If the DVR and the camera are not connected properly, OSD ‘L’(LOSS) will be displayed on screen.
SHR-1040/SHR-1040K-ENG 2006.4.4 11:12 AM ˘ ` 2-12
To Next Page
Loading...
