To Next Page
L
Lawrence PerezAug 16, 2025
How to connect to Samsung SNB-7000 using a tab browser of Internet Explorer 7.0?
- WWilliam ReidAug 16, 2025
Instead of using a tab browser, open a new browser window to connect to the system.
How to connect to Samsung SNB-7000 using a tab browser of Internet Explorer 7.0?
Instead of using a tab browser, open a new browser window to connect to the system.
How to fix Samsung IP Camera when I can’t access it from a web browser?
If you're having trouble accessing your Samsung IP Camera through a web browser, here are a few things to check: * Ensure the camera's network settings are correctly configured. * Verify that all network cables are properly connected. * If using DHCP, confirm the camera obtains dynamic IP addresses without issues. * When using a DDNS URL, double-check that the MAC address is entered accurately. * If the camera connects through a broadband router, make sure port forwarding is set up correctly.
Why does my Samsung IP Camera viewer get disconnected during monitoring?
If your Samsung IP Camera viewer disconnects during monitoring, here are some potential reasons: * First, check all network connections to ensure they are stable. * If your camera is connected over a PPPoE network, poor network conditions can cause disconnections.
What to do if Samsung IP Camera connected to the network is not detected in the IP installer program?
If your Samsung IP Camera isn't detected in the IP installer program, try turning off the firewall settings on your PC and then search for the camera again.
What to do if I cannot record into the SD memory card of my Samsung IP Camera?
If you're unable to record to the SD memory card in your Samsung IP Camera, consider the following: * Verify that the memory card isn't defective. * Check if the write protection tab on the memory card is set to “LOCK.” If it is, switch it to the unlocked position.
What to do if a SD memory card is inserted but the Samsung IP Camera does not recognize it?
If your Samsung IP Camera doesn't recognize the SD memory card, try these steps: * Make sure the memory card is inserted in the correct direction. * Format the memory card again using the camera's menu: go to ? ? .
Why does my Samsung IP Camera show no image?
If your Samsung IP Camera displays no image, and the transmission method is set to multicast, verify that the LAN the camera is connected to has a router that supports multicast.
Why Samsung IP Camera images overlap?
If you're experiencing overlapping images with your Samsung IP Camera, check if multiple cameras are set to the same multicast address instead of unique addresses.
Why I cannot connect to Samsung IP Camera using a tab browser of Internet Explorer 7.0?
If you're unable to connect to your Samsung IP Camera using a tab browser in Internet Explorer 7.0, try opening a new browser window instead of using a tab.
How to fix Samsung IP Camera when I cannot format the SD memory card?
If you are unable to format the SD memory card for your Samsung IP Camera, check if the write protection tab of the memory card is set to “LOCK.” If it is, switch it to the unlocked position.
Critical safety precautions for installation and operation.
Explains warnings, cautions, and graphical symbols used in the manual.
Details camera functionalities, PC requirements, and memory card specifications.
Steps to connect the camera to LAN, modems, and routers for network access.
Setting up motion detection and intelligent video analysis features.
Common problems and their solutions for accessing and operating the camera.
General| Total megapixels | 3 MP |
|---|---|
| Maximum resolution | 2048 x 1536 pixels |
| Supported video modes | 1080p, 720p |
| Video formats supported | H.264, MPEG |
| Analog signal format system | - |
| Supported graphics resolutions | 320 x 240, 1280 x 960, 1024 x 768 (XGA), 1280 x 1024 (SXGA), 1280 x 720 (HD 720), 1600 x 1200 (UXGA), 1920 x 1080 (HD 1080), 2048 x 1536 (QXGA), 640 x 480 (VGA), 800 x 600 (SVGA) |
| White balance | Manual |
| Minimum illumination | 0.001 lx |
| Sensor type | CMOS |
| Progressive scan | Yes |
| Optical sensor size | 1/2.8 \ |
| Optical zoom | - x |
| Security algorithms | HTTPS |
| Compatible memory cards | SD, SDHC |
| LED type | IR |
| Type | IP security camera |
| Placement supported | Indoor & outdoor |
| Connectivity technology | Wired |
| Form factor | Bullet |
| Product color | Gray |
| Housing material | Metal |
| Interface | RJ-45 |
| Ethernet LAN (RJ-45) ports | 1 |
| Signal-to-Noise Ratio (SNR) | 50 dB |
| Wi-Fi | No |
| Cabling technology | 10/100Base-T(X) |
| Supported network protocols | TCP/IP, UDP/IP, RTP(UDP), RTP(TCP), RTSP, NTP, HTTP, HTTPS, SSL, DHCP, PPPoE FTP, SMTP, ICMP, IGMP, SNMPv1/v2c/v3(MIB-2), ARP, DNS, DDNS |
| Power requirements | 12V DC, 24V AC, PoE (IEEE802.3af) |
| Compliance industry standards | IEEE 802.1x, 802.3af |
| AC input voltage | 12 V |
| Power source type | PoE |
| Power consumption (typical) | 7 W |
| Sustainability certificates | RoHS |
| Operating temperature (T-T) | -10 - 50 °C |
| Operating relative humidity (H-H) | -20 - 80 % |
Weight and Dimensions| Depth | 138.6 mm |
|---|---|
| Width | 72 mm |
| Height | 60 mm |
| Weight | 440 g |
