How to fix Samsung SNB-7002 Security Camera when I can’t access it from a web browser?
First, ensure the camera's network settings are correctly configured. Then, verify that all network cables are properly connected. If you are using DHCP, confirm that the camera can obtain dynamic IP addresses without issues. Lastly, if the camera is connected to a broadband router, check that port forwarding is set up correctly.
What to do if Samsung SNB-7002 connected to the network is not detected in the IP installer program?
Turn off the firewall settings on your PC and then search for the camera again.
Why does my Samsung SNB-7002 viewer get disconnected during monitoring?
Connected viewers may disconnect if there are any changes to the camera or network configurations. Check all network connections to ensure they are stable. If the camera is connected over a PPPoE network, poor network conditions may also cause disconnections.
Why am I not receiving notification emails from my Samsung SNB-7002 Security Camera when motion detection is enabled?
Verify the settings in the following sequence: 1. Check the Data & Time settings. 2. Ensure that Motion detection / Video analytics is set to Enable. 3. Confirm that the E-mail option in the Event action setup menu is checked.
What to do if Samsung SNB-7002 Security Camera does not operate properly with inserted SD memory card?
First, check if the memory card is inserted in the proper direction. Note that the camera's operation is not guaranteed with memory cards formatted by other devices. Try formatting the memory card again in the Setup ? Event ? Storage menu.
Why Samsung SNB-7002 Security Camera cannot record into the SD memory card?
Check if the memory card is defective. Also, verify that the write protection tab on the memory card is not set to “LOCK.”
How to connect to Samsung SNB-7002 Security Camera system if I cannot connect using a tab browser of Internet Explorer 7.0?
When connecting to the system using a tab browser, the same cookie information is shared, which can cause errors. Instead of using a tab browser, open a new browser window to connect to the system.
Why do images overlap on my Samsung SNB-7002 Security Camera?
Check whether two or more cameras are set to a single multicast address instead of different addresses. If multiple cameras use a single address, the images may overlap.
Why Samsung SNB-7002 cannot format the SD memory card?
Check if the write protection tab of the memory card is set to “LOCK.”
Essential safety guidelines to prevent hazards and ensure proper operation.
Steps for connecting the camera directly to LAN, DHCP, PPPoE, and Broadband Router environments.
Manual configuration of IP addresses, subnet masks, and gateways for network connectivity.
Using the IP Installer to automatically configure network settings for the camera.
Setting up and checking the camera in a dynamic IP environment using DHCP protocols.
Configuring port forwarding on routers to enable remote access to the camera via its web viewer.
Methods for accessing the camera using IP addresses, URLs, and checking DDNS status.
Settings for video profiles, quality, privacy zones, audio codecs, and camera parameters.
Configuration of network interfaces, ports, DDNS, IP filtering, SSL, 802.1x, QoS, and SNMP.
Configuration of FTP/Email servers, storage, alarm inputs, time schedules, and detection events.
Solutions for web browser access, viewer disconnection, and IP installer detection failures.
General| Model | SNB-7002 |
|---|---|
| Type | Network Camera |
| Sensor Type | 1/2.8" CMOS |
| Video Compression | H.264, MJPEG |
| Audio Compression | G.711, G.726 |
| Network Interface | RJ-45 (10/100BASE-T) |
| Ethernet | Yes |
| Ingress Protection | IP66 |
| Frame Rate | 30 fps |
| Day/Night | ICR |
| Wide Dynamic Range | Digital WDR |
| Audio | Two-way audio support |
| Power Supply | PoE (IEEE802.3af), 12V DC |
| Operating Temperature | -10°C to +55°C |
To Next Page
