Samsung SNB-7002 - Audio Detection

setup screen
Audio detection
You can set to detect sound over the specified level and trigger an event accordingly.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <Event setup>.
3.
Select
<Audio detection>
from
<Event
action setup>
.
4.
Set whether or not to
< Enable >
.
5. Set the audio detection’s sound level.
The lower the level, the smaller the
sound change is detected.
6. Specify the activation time and
activation condition.

For more information about
<
Activation
time
>
and
<
Action
>
, refer to “Alarm input”.
(page 103)
7. When done, click [Apply (
)].
M

If detected audio level is too low, set the audio input gain to a higher level in <Audio setup>.
Network disconnection
You can receive and save events of a physically disconnected network.
1. Fr
om the Setup menu, select the
<Event ( )> tab.
2. Click <Event setup>.
3.
Select
<Network disconnection>
from
<Event action setup>
.
4.
Set whether or not to
< Enable >
.
5. Specify the activation time and
activation condition.

For more information about <Activation
time> and <Action>, refer to “Alarm input”.
(page 103)
6. When done, click [Apply (
)].
114_ setup screen