Samsung SNB-7002 - Camera Setup

setup screen
• Codec : Sets the codec to be used.
- G.711 : A audio codec standard, it uses 64 Kbps PCM (Pulse Code Modulation)
encoding.
ITU standard audio codec that is adequate for digital voice transfer in PSTN
network or through a PBX.
- G.726 : ITU standard audio codec applying ADPCM (Adaptive Differential Pulse
Code Modulation) for variable bit rates of 40/32/24/16 Kbps to 64 Kbps PCM
encoding.
• Bitrate : Set the bit rate to differentiate compression ratio if using G.726 codec.
• Gain : Sets the input audio gain.
4. Set the audio output level.
• Enable : Sets whether to use audio output.
• Gain : Sets the output audio gain.
5. When done, click [Apply (
)].
Camera setup
You can change the camera settings according to the environment where the camera is
located.
1. From the Setup menu, select the
<Video & Audio (
)> tab.
2. Click <Camera setup>.
3.
Configure the settings as necessary of :
SSDR, White balance, Backlight,
Exposure, Special, OSD, Time OSD
4. When done, click [Apply (
)].

If a certain time (timeout: 240s) is elapsed with
your not pressing the [Apply (
)]
button after changing the settings, your
changes will not be applied.
80_ setup screen