To use Video analytics
It detects event that meets all conditions specified by sensitivity, size and area and the
event condition rules.
1. Select the video analysis mode.
2. Set <Sensitivity>, <Size> and <Area>.
For further details on settings, refer
to “To use Motion detection”. (page
91~92)
3. Select <Analytics> tab.
4. Select the video analysis type.
• Passing, Entering/Exiting : Detects
motions of passing, entering into or
exiting from a virtual line specified by
the user.
• Appearing (Disappearing) : Detects
motions of appearing on or
disappearing from the user-defined
area or the entire screen area.
5. Set the video analysis rules.
For further details on settings, refer to
“To set the video analysis rules”.
(page 94~95)
6. Set whether to use <Detection result
overlay>.
Specified rules of virtual lines and areas
are displayed on the monitoring page.
7. When done, click [Apply (
)].
English _93
● SETUP SCREEN
To Next Page
Loading...
