English _51
● SETUP SCREEN
Smart codec setup
Set a desired area of the video incoming from the camera as ROI area and specify the
detection sensitivity for the area.
1. From the Setup menu, select the
<Audio & Video (
)> tab.
2. Click <Smart codec setup>.
3. Select ROI Area.
• Face Detection : Active if a face is
recognized on the monitoring screen.
M
Face detection can be worked when
the following conditions are satisfied:
-
Face Direction : R/L ±45 upward
-
Rotation Angle of Face : Length ±30, Width ±60
-
Minimum Size of Face : Larger than 20×20, based on the resolution of 320×240
• Manual : Specify the ROI area to monitor manually.
4. Select a quality and detection sensitivity for the ROI area.
5. If manually specifying the ROI area, select a desired area with the mouse pointer and
drag it as much as you want.
You can specify up to 5 distinct areas.
6. To cancel your selection, simply click [
].
7. When done, click [Apply ( )].
J
The Smart codec will not be active if it is set to <Off> in <Video profile>. (page 42)
To Next Page
Loading...
