PTZ CONTROLLER User Guide
16
PTZ CONTROLLER User Guide
17
■
Enables changing the controller password.
■
Resets the controller’s current settings to the factory
release default values and optimizes the joystick
calibration.
■
Turns the sound of controller buttons on or off.
■
Select a PTZ serial command transfer cycle for using
the joystick. Shortening the transfer cycle increases
the response speed of the camera.
■
To prevent the attenuation of communication signals
between the camera and controller, the controller’s
termination option must be ON if it is located farthest from
the camera and controller communication loop. If the
controller is in the middle of the camera and controller
communication loop, turn the termination option off.
■
If no joystick or button input is detected for a set
duration, the LCD screen turns itself off and enters
Sleep mode.
Setting Up Controller Environment
2-4. Sleep
2-5. Buzzer
2-6. Terminate
2-7. Joystick’s Serial Command Transfer Cycle
•
Shortening the joystick's serial command transfer cycle may cause certain camera models to not
process commands properly. To prevent and resolve such malfunctions, extend the transfer cycle.
Notes
2-8. Password
2-9. Factory Set
Setting Up Controller Environment
To Next Page
Loading...
Need help?
General
