PTZ CONTROLLER User Guide
18
PTZ CONTROLLER User Guide
19
Design
Joystick in the Center
Move to the far left side
Move to the far right side
Move to the far upper side
Move to the far lower side
Rotate to the Wide direction as far as possible
Rotate to the Tele direction as far as possible
Select <YES> to save the changes and move
back to the initial screen. Select <NO> or press
the ESC button to cancel changes and move back
to the initial screen.
Setting Up Controller Environment
3. Joystick Calibration
①
Press 3 on the number pad.
②
Hold down the SET button to enter the Joystick Calibration mode.
③
At each option, move the joystick as far as you can, and then press the ENT button to
calibrate.
Troubleshooting
●
If the power is not turned on
▶
Please check if the controller is connected to the power adapter.
●
If the joystick does not move, or the controller buttons are not pressed
▶
There may be a problem with the controller board. Please contact your nearest dealer for further
assistance.
●
If the controller cannot control the camera
▶
Please check the network cable between the controller and camera.
▶
Please check if you have selected the correct ID for the camera on the controller.
▶
Please check the protocol and serial settings of the controller and camera.
To Next Page
Loading...
Need help?
General
