Samsung SR10F71UC - STARTING AND STOPPING CLEANING

operating _27
03 OPERATING
USING THE VACUUM CLEANING ROBOT
Starting/Stopping Cleaning
You can run or stop all vacuum cleaning robot functions.
■
Each vacuum cleaning robot function only runs when the
Power Switch is turned on.
■
When the vacuum cleaning robot is operating, press the
button to cancel the operation and select a function.
Turning the power on or off
Turning the power on
- Main unit: Press the
button.
Turning the power off
- Remote control: Press the
button.
- Main unit: Press and hold the
button down for 3 seconds.
❈
If no key is pressed for approximately 1 minute after turning the power
on, the power is automatically cut to prevent the battery discharging.
To turn the power on again, press and hold the power (
) button on
the main body.
Starting or stopping cleaning
Starting
- Remote control : Press the Auto, Spot, Max, Manual button.
- Main unit : Select Auto, Spot, Max mode by using the
button
and then pressing the button.
- When cleaning begins, the vacuum cleaning robot starts to move.
❈
Pressing the button without selecting cleaning mode starts to
perform the Auto mode cleaning.
Stopping
- To stop, press the
remote control or main unit button.
- When cleaning is stopped, the vacuum cleaning robot stops.
Using the main unit
Using the main unit
buttons
buttons
Using the remote
Using the remote
control
control
DJ68-00691B-EN.indd 27DJ68-00691B-EN.indd 27 13. 01. 30 오후 8:2213. 01. 30 오후 8:22