English _23
CONNECTING WITH OTHER DEVICE
CONNECTING EXTERNAL SATA HDD (eSATA)
M
The external SATA connection port is not available in SRD-830/830D/830DC/1610/1610D/1610DC/1630/1630D/1630DC.
1. Two external SATA ports are provided on the rear panel by factory default.
2. If connected to the system, the external SATA HDD (eSATA) can be recognized and configured in “Menu >
Device > Storage Device”.
J
Only one SATA HDD can be connected to an external SATA port.
Use a cable shorter than 1 m for the external external SATA HDD (eSATA) connections.
Unexpected disconnection to a device in use which is connected via eSATA may restart the system. Check whether the
device is in use before disconnecting it.
CONNECTING POS DEVICE
1. You can connect a POS device to the RS-232C port on the product’s rear side when you connect it directly with
a RS-232C cable.
2. Connection setup for the RS-232C port is available in “Menu > Device > POS Devices”, press the
<POS Device Setup> button and set <Baudrate, Parity, Data, Stop bit and Transfer Type>. (Page 52)
CONNECTING THE ALARM INPUT/OUTPUT
The Alarm In/Out port at the back is composed of the following.
1. Alarm In Port for SRD-830/830D/830DC/850/850D/850DC/
870/870D/870DC
2. Alarm In Port for SRD-1610/1610D/1610DC/1630/1630D/1630DC/
1650/1650D/1650DC/1670/1670D/1670DC
3. Alarm Out Port
ALARM IN
NO CONNECTION
ALARM IN
ALARM OUT
To Next Page
Loading...
