Samsung SRD-1653D - Connecting and Setting the Network

70_ main menu
main menu
Connecting and Setting the Network
Networking may differ from the connection method, check your environment before setting the connection mode.
When no router is used
• Static mode
- Internet connection : Static
PPPoE, leased line, and LAN environments allows connection between the DVR
and remote user.
- DVR Network Settings : Set the <Connection Mode> in
<Interface> menu of the connected DVR to <Static>.
 Consult your network manager for IP Address, Gateway and
Subnet Mask.
• DHCP mode
- Internet connection : Connect the DVR directly to a cable
modem, DHCP
PPPoE modem or FTTH network.
- DVR Network Settings : Set the <Connection Mode> in
<Interface> menu of the connected DVR to <DHCP>.
• PPPoE mode
- Internet connection : An PPPoE modem is directly connected to the DVR, where the PPPoE connection
requires user ID and password.
- DVR Network Settings : Set the <Connection Mode> in
<Interface> menu of the connected DVR to <PPPoE>.
 <ID> and <Password> should be the same to the PPPoE user
information.
If you don’t know the ID and password, consult your PPPoE service
provider.
Connection Mode
Interface
Port

IP Type Static

Transfer Bandwidth 2Mbps
OK Cancel

IP
Address 192.168.1.200

Gateway 192.168.1.1

Subnet Mask 255.255.255.0

DNS
Manual 168.126.63.1
Connection Mode
Interface
Port

IP Type PPPoE

Transfer Bandwidth 600kbps
OK Cancel

IP
Address 192.168.1.200

Gateway
192.168.1.1

Subnet Mask
255.255.255.0

DNS Manual 168.126.63.1

ID ID

Password
************