42_ using the DVR
using the DVR
M
<Check> status means that the HDD is operating but it has problems that require technical examination.
(
) appears on the Live screen.
<Replace> status means that the HDD has defect and requires immediate replacement.
( ) appears on the Live screen.
4. When the HDD Alarm setup is done, press <OK>.
Remote Devices
You can set the RS-485 communication for use of PTZ Camera and system keyboard with the DVR.
Using the mouse may help make setup easier.
1. Use the up/down buttons (
▲▼
) in <Device> window to
move to <Remote Device>, and press [ENTER] button.
2. Use direction buttons (
▲▼◄ ►
) to move to the desired
item, and press [ENTER] button.
3. Set the values of each communication setup of the remote
device.
• Baudrate : Baud rate settings of the DVR, PTZ camera and
system keyboard should be matched for proper operations.
4. Specify the system keyboard and remote control ID, and
click <OK>.
M
For changing the remote control’s ID, refer to “Changing the Remote Control ID”. (Page 11)
S y s t e m K e y b o a r d O F F I D 1
R e m o t e C o n t r o l O N I D 0
B a u d r a t e P a r i t y D a t a S t o p B i t T r a n s f e r t y p e
9 6 0 0
N o n e
8
1
H a l f D u p l e x
Remote Device
O K C a n c e l
To Next Page
Loading...
