99
Using MDC
Chapter 09
Multi Control
Multi Control
Multi Control
Move
Enter
Return
ID Setup : 00
ID Input : --
MDC Connection : RJ45 MDC
Network Setting
-
The displayed image may differ depending on the model.
•
ID Setup
Assigns distinctive IDs to the SET.
•
ID Input
Use to select the transmitter functions of the individual SET. Only a SET where the ID corresponds
to the transmitter setting becomes activated.
•
MDC Connection
Selects a port to receive the MDC inputs from.
―
RS232C MDC: Communicates with the MDC via a RS232C MDC cable.
―
RJ45 MDC: Communicates with the MDC via an RJ45 MDC cable.
•
Network Setting
IP Setting : Manual, Auto
IP Address : Manually enter the IP Address if IP Setting is set to Manual.
Subnet Mask : Manually enter the Subnet Mask if IP Setting is set to Manual.
Gateway : Manually enter the Gateway if IP Setting is set to Manual.
To Next Page
Loading...
