Samsung UN32C5000QF - Factory Mode Adjustments

4-50
4. Troubleshooting
4-3. Factory Mode Adjustments
4-3-1. Entering Factory Mode
To enter ‘Service Mode’ Press the remote -control keys in this sequence :
- If you do not have Factory remote - control
MUTEPower OFF 1 8 2 Power On
4-3-2. How to Access Service Mode
1. Using the Customer Remote
Turn the power off and set to stand-by mode1.
Press the remote buttons in this order; MUTE-1-8-2-POWER ON to turn the set on.2.
The set turns on and enters service mode. This may take approximately 20 seconds.3.
Press the Power button to exit and store data in memory. 4.
- If you fail to enter service mode, repeat steps 1 and 2 above.
Initial SERVICE MODE DISPLAY State 5.
A TYPE B Tpye
Option Option
Control Control
SVC SVC
Expert Expert
ADC/WB ADC/WB
Advanced Advanced
T-TDT5AUSC-XXX
T-TDT5AUSS-XXX
EDID SUCCESS
CALIB : AV X COM X PC X HDMI X
Option : XXXX XXXX XXXX X
SDAL-XXX
RFS : P0154 T-TDT5AKSRC
20XX-XX-XX
TYPE : XX
MODEL : XXXXX
MAC FAIL
FACTORY DATA VER : XXX
EERC VERSION : XXX
DTP-AP-COMP-310-01
DTP-HIIG-0304
DTP-BP-0314
DATE OF PURCHASE : XX/XX/XX
T-MSX5AUSC-XXX
T-MSX5AUSS-XXX
EDID SUCCESS
CALIB : AV X COM X PC X HDMI X
Option : XXXX XXXX XXXX X
SDAL-XXX
RFS : P0154 T-TDT5AKSRC
20XX-XX-XX
TYPE : XX
MODEL : XXXXX
MAC FAIL
FACTORY DATA VER : XXX
EERC VERSION : XXX
DTP-AP-COMP-310-01
DTP-HIIG-0304
DTP-BP-0314
DATE OF PURCHASE : XX/XX/XX
* How to enter the hidden factory mode.
a. into the factory mode
b. scroll down and highlight advanced
c. key input : 0 + 0 + 0 + 0
** hidden menu : Picture
But you can't modify the menu (2010 models)
6. Buttons operations withn Service Mode
Menu Full Menu Display/Move to Parent Menu
Direction Keys /
Item Selection by Moving the Cursor
Direction Keys /
Data Increase / Decrease for the Selected Item
Source
Cycles through the active input source that are connected to the unit
Using the factory remote : Info + factory key