Error Codes
Unit keeps running non stop -
If you have this issue with this
unit replace the Main PCB,
software in the board has
changed it will correct this
symptom.
Error Code Check Hold TEMP 3 Seconds
ATC (Auto Temperature Control)
ATC is the control function that the washer controls water temperature with temperature sensor (thermistor).
Because there are numerous water temperatures depending on the customer’s environments (cold
areas, warm areas, various water temperatures, settings of heater temperature, etc.), ATC function in
our washer maintains the certain level of wash temperature to output the best washing performance at
each cycle.
If you select normal cycle, this cycle is the regulation and UL cycle. Since new washers must reduce
the amount of energy usage as a first priority, customers will notice more cold water entering the
washer. But, this is normal, not a problem.
In this regulation cycle, Hot temperature is similar to acceptable adult bath-water temperature and
warm temperature is similar to comfortable swimming-pool water temperature.
If customers want to wash clothes in specific water temperatures, customers should choose a different
cycle at each temperature (Hot/Warm).
To Next Page
Loading...
