10 _ Disassembly and Reassembly
3-2. DISASSEMBLY
Part Figure Description
Sub and Main PCB
(continued)
1. Remove the 6 screws holding the control panel
assembly and separate cover panel.
3. Separate the cover panel upward.
*
4. Remove the 2 screws holding the control panel
assembly and turn the panel over.
5. Pull the Encoder-Knob to separate it and then
When reassembling the PCB, take care that
you do not damage the control-panel xing
hook. After replacing the sub PCB, check the
key operation.
To Next Page
Loading...
