18 _ Troubleshooting
4. TROUBLESHOOTING
4-1. TEST MODE
No mode How to enter
1 Smart Install
Standby
Set the scheduled
for 7 seconds
Smart Install
2
Smart Install
3
Enter Smart Install
turn when pressing delay end.
4
Enter Smart Install
5
Enter Smart Install
Automatic Mode of Smart Install
Manual Mode of Smart Install
Operation
mode
Description
Operation
mode
Description
1 7 carry out test for operation of drainage pump
2 carry out test for drainage pump operation 8 carry out test for operation of dehydration
3 carry out test for operation of preparatory valve 9 carry out test for operation of drying heater and drying fan
Co carry out test for operation of cold water valve 10 carry out test for operation of machine door
Ho carry out test for operation of hot water valve
OK(Ot) Automatic mode of Smart Install is completed normally
6
carry out test for operation of water shot valve
carry out test for operation of washing heater
carry out test for operation of rinsing
Identity of Smart Install completion
「OK(Ot)」 a identity will display.
「nG」 identity will display.
Result Enquiry of Automatic Mode of Smart Install
「OK(Ot)」
「nG」 identity will appear.
Diagnosis Information Display Mode
「AS」 「CR」 identity
will appear and diagnosis information display mode is entered.
「CR」
diagnosis codes generated before will display 7 digits at most.
To Next Page
Loading...
