Troubleshooting _ 21
4-3. CORRECTIVE ACTIONS FOR EACH CODE
Error Type
Error
Mode
Causes Corrective Actions Description of Photo
Water Level
Sensor
1C
level sensor is
defective.
water level
sensor terminal
is properly
connected.
level sensor hose
when The main
PCB is defective.
terminal connections.
level sensor, because if an incorrect
part is used, an abnormal operation
may occur. (Abnormal operation)
replace it.
the procedures above, replace the
PBA.
sensor and the connector are
connected.
Color Wire Oragne Color Wire
without water (Min 25.9KHz)
Washing
Motor Error
and Hall
Sensor Error
3C
fault
hall sensor fault
connections
of the washing
connector
rotor and stator
fault
connections and contacts.
occurs due to too much laundry.
replace the hall sensor.
motor cover is damaged.
foreign material.
replace the PBA.
resistances at any two of the three
PCB motor(Between pins 2 and 4, 3
and 4 of the four (4) pins)
power is on.
CN 1
2-Hall-A
3-Hall-B
4-GND
5-Clutch Hall IC
To Next Page
Loading...
