16 _ Disassembly and Reassembly
Part Figure Description
Clutch
(continued)
5. Remove the bolt holding the pulsator with a
10mm wrench according to the direction of
arrow
6. Remove the shaft with the jig wrench.
direction.
7. Place the main body so that the front
frame faces upward and remove the 2 bolts
holding the saddle with a 10mm wrench.
When you place the washer on the oor,
take care that you do not damage or
scratch the product.
8. Remove the belt.
When you replace belt, check belt
tension certainly.
9. Remove the NUT with a 17mm wrench and
remove ASSY PULLEY MOTOR.
To Next Page
Loading...
