Samsung WA476DSHASU/A1 - Key Features of Your New Washer; VRT (Vibration Reduction Technology); The Largest Capacity; PureCycle (Tub Cleaning cycle)

ALIGNMENT AND ADJUSTMENTS
2
GENERAL ERROR FUNCTION
NO
Error Code
(Diagnostic Code
Error Image)
Description Corrective Action
1 nd
Thewaterlevelfailstodropbelowthe
ResetWaterLevelwithin30minutes.
Goto“WillNotDrain”Troubleshooting
Section.
2 LO
DoorfailstoUnlockAfter7attempts.
Goto“WillNotUnlock”
TroubleshootingSection.
3 nF
WhenthellingContinuesformore
than60minutesorthereisnochange
ofwaterlevelfor6minutes.
Goto“NoWaterFill”Troubleshooting
Section.
4 FL
Doorfailstolockafter7attempts.
Goto“WillNotLock”Troubleshooting
Section.
5 LE
AwaterlevellowerthantheReset
waterlevelisdetectedfor5seconds
duringtheWash/Rinsecycle.
Goto“NoWaterFill”Troubleshooting
Section.
6 1E
WaterLevelSensorTrouble.(When
theinputsignalfromthewaterlevel
sensorisoutofrange,theunitwill
sendoutbeepingsoundsandhalts
thecycle.)
Goto“NoWaterFill”
TroubleshootingSection
7 OE
Afaultisdetectedinthewaterlevel
sensor.Data(frequency)showsthe
waterlevelisatorabovetheoverow
waterlevel.(Whenthiscondition
isdetected,themachinewill
automaticallystartsdrainingwater
untilthewaterlevelfallsbelowthe
resetwaterlevel)
Firstchecktoseethatallofwater
valvesarenotstuck.Ifwatervalves
areOK,checkwaterlevel.
8 dc
Unbalanceorcabinetbumpis
detectedduringnalspin
Goto“WetClothes”Troubleshooting
Section.
9 E2
JammedKey.(Whenkeyinputsignals
arecomingoutformorethan30
seconds,itisregardedasajam.)
Checkallofkeys.IfAkeyissensed
tobepressed,allkeyswilldonot
respond.
10 ds
Doorisdetectedasopenwhileitis
tryingtolockthedoor.
Goto“QuickTestMode”andthendo
DoorLock/UnlockTest
Toavoidriskofelectricalshock,personalinjuryordeath;disconnectpowertowasher
beforeservicing,unlesstestingrequirespower.
WARNING
[Technical information]WA484DSHA_03051B_EN.indd 2 2012-06-25 �� 11:11:58