Samsung WAM3501 - Connecting the Power Cord

❚
Connecting the Power Cord
<WAM5500, WAM3500, WAM3501>
1 Connect the power cord of your speaker as shown. It will connect at an angle.
2 Push the power cord into the notch at the edge of the speaker bottom.
This lets the speaker rest flat when you stand it up.
SPK ADD/Wi-Fi SETUP SERVICE1 SERVICE2 POWER
ADD SPK/Wi-Fi SETUP SERVICE1 SERVICE2 POWER
SPK ADD/Wi-Fi SETUP SERVICE
POWER
SPK ADD/Wi-Fi SETUP SERVICE
POWER
< WAM5500/WAM3500 > < WAM3501 >
<WAM1500, WAM1501>
1 Connect the adaptor’s input power cord to the adaptor. (WAM1500 Only)
2 Connect the adaptor’s output power cord to the DC 19V jack on the speaker.
3 Push the power cord into the notch at the edge of the speaker bottom.
This lets the speaker rest flat when you stand it up.
SPK ADD/Wi-Fi SETUP SERVICE
DC 19V
< WAM1500 >
SPK ADD/Wi-Fi SETUP SERVICE
DC 19V
< WAM1501 >
NOTE
9
Make sure to rest the AC/DC Adapter flat on a table or the floor. If you place the AC/DC Adapter so that
it is hanging with the AC cord input facing upwards, water or other foreign substances could enter the
Adapter and cause the Adapter to malfunction.
11
44