English - 16
STEP 4 - Connect the water hose
Connect the water supply hose to the water tap.
1. Remove the adaptor (A) from the water supply hose (B).
2. Use a Philips screwdriver to loosen four screws on the
adaptor.
3. Hold the adaptor and turn part (C) in the arrow direction to
loosen it by 5 mm (*).
4. Insert the adaptor into the water tap, and tighten the screws
while lifting up the adaptor.
5. Turn part (C) in the arrow direction to tighten it.
6. While holding down part (E), connect the water supply hose
to the adaptor. Then, release part (E). The hose fits into the
adaptor with a clicking sound.
Untitled-4 16 2016-04-07 3:24:34
To Next Page
Loading...
