Samsung WF45B6300AP - Operations; Simple Steps to Start; Control Panel

English
English 15
Operations
WARNING
To reduce the risk of fire, electric shock, or injury to persons, read the Safety information before operating
this appliance.
Simple steps to start
1. Press Power to turn on the washer.
2. Turn the Cycle Selector to select a cycle.
3. Change the cycle settings (Temp., Rinse, Spin, and Soil) as necessary.
4. Select desired options as necessary.
5. Press and hold Start/Pause (Hold to Start).
To change the cycle during operation
1. Press Start/Pause (Hold to Start) to stop operation.
2. Select a different cycle.
3. Press and hold Start/Pause (Hold to Start) again to start the new cycle.
Control panel
NOTE
Available cycles can vary depending on the models. For the detailed information, refer to the user manual
on the Samsung website (http://www.samsung.com).
• Visit the Samsung website, go to Support > Support home, and then enter the model name.
Cycle Selector
Turn the Cycle Selector to select a desired cycle. When a cycle is
selected, the cycle indicator lights up.
Digital Graphic Display
Displays all cycle information, including the cycle time, information
code, and operating status.
Temp. Press and tap to change the water temperature for the current cycle.
Rinse Press to change the rinse count for the current cycle.
Spin Press and tap to change the spinning speed for the current cycle.
Soil Press and tap to change the soil level for the current cycle.
Pre Soak
Press to add 30 minutes of soaking time at the start of the wash cycle
for better stain removal.
Super Speed
Press this button if you need to shorten the washing time. The
shortened time may differ depending on the selected cycle/load/
options.
Delay End
Set the washer to finish your wash automatically at later time. Choose a
delay of between 1 to 24 hours (in 1 hour increments).
DC68-04355C-01_IB_WASHER_EN.indd 15 2023-06-15  6:20:14