Installation
Installation
English24
To connect the water hoses to the faucets:
1. Connect one end of each water hose to
the Hot or Cold tap.
2. Turn the ttings by hand until they are
tight, and then tighten them by just an
additional two-thirds of a turn with a
pliers. Do not overtighten the ttings.
You can damage them.
3. When done, pull the water hoses up
and down to check if they are properly
connected.
4. Put the other ends of the hoses into
a bucket and open the taps for 10-15
seconds to remove impurities. When
done, close the taps.
WF5500M_DC68-03876A-02_EN.indd 24 2019-02-12 5:55:14
To Next Page
Loading...
