How to reduce excessive suds in my Samsung Washer?
If your Samsung Washer has excessive suds, use the recommended types and amounts of detergent. Use high efficiency (HE) detergent to prevent oversudsing. Reduce the detergent amount for soft water, small loads, or lightly soiled loads. Do not use Non-HE detergent.
What to do if the electronic control needs to be checked on a Samsung Washer?
Check if power is supplied properly to your Samsung Washer. If the information code remains, contact a Samsung service center.
What to do if water may overflow on a Samsung WF45R6300A Washer?
Close the water valve and call for service.
What to do if laundry needs protection because the water being supplied is too hot on a Samsung WF45R6300A Washer?
Make sure the cold and hot water taps are properly connected. Power the Samsung Washer off. Wait 2-3 minutes, power the washer on, and then try again.
Why can't I add additional detergent to my Samsung WF45R6300A?
Make sure the remaining amount of detergent and fabric softener is not over the limit in your Samsung Washer.
What to do if the door is open on my Samsung WF45R6300A?
Close the Samsung Washer door and press Start/Pause to resume operation.
Why does my Samsung WF45R6300A Washer have odors?
If your Samsung Washer has odors, excessive suds may be collecting in recesses. Run cleansing cycles to sanitize periodically, clean the door seal (diaphragm), and dry the washer interior after each cycle.
Why does my Samsung WF45R6300A Washer fill with the wrong temperature water?
If your Samsung Washer fills with the wrong temperature water, fully open both taps. Ensure the temperature selection is correct and the hoses are connected to the correct taps. Flush the water lines. Set your water heater to supply hot water with a minimum temperature of 120 °F (49 °C) at the tap, and check its capacity and recovery rate. Clean the mesh filters on the hoses, as they may be clogged. The water temperature may change during filling as the automatic temperature control feature checks incoming water temperature.
Why is the load still wet after a Samsung WF45R6300A cycle?
If your Samsung Washer load is wet at the end of a cycle, use the High or Extra High spin speed. Use high efficiency (HE) detergent to reduce oversudsing. Note that small loads may become unbalanced and not spin completely. Ensure the drain hose is not kinked or clogged.
How to fix a Samsung Washer that does not start?
If your Samsung Washer does not start, ensure it's properly plugged in and the door is securely closed. Check that the faucets are open, and press the Start/Pause button. Also, verify that Child Lock is deactivated. Be aware that the washer makes clicking noises and does a quick drain before filling. Finally, inspect the fuse or reset the circuit breaker.
Explains the meaning of safety icons and the importance of following instructions.
Explains the meaning of various warning icons used throughout the manual.
Lists crucial precautions to reduce risks of fire, electric shock, and injury during appliance use.
A mandatory warning regarding cancer and reproductive harm as per California law.
Highlights critical safety warnings related to the proper installation of the washer.
Provides cautions to ensure safe installation and prevent product damage or injury.
Details critical warnings for safe operation and usage of the washing machine.
Offers important cautions for the everyday use of the washing machine to prevent issues.
Lists critical warnings to follow when cleaning the washer to avoid damage or hazards.
Information regarding FCC compliance, rules, and statements for radio frequency emissions.
Details Industry Canada compliance, technical specifications, and statements.
Information on obtaining source code for open-source software included in the product.
Step-by-step instructions for unpacking the washing machine and checking for damage.
Lists all the parts and accessories that should be included with the washer.
Identifies supplied parts, parts not supplied, and tools required for installation.
Details electrical supply, grounding, and water supply requirements for proper installation.
Guidance on drain hose setup, flooring suitability, and water temperature considerations.
Specifies required clearances for different installation types, including alcoves and closets.
Illustrates various installation configurations such as undercounter, pedestal, and stacked setups.
Guidelines for choosing an appropriate location for installing the washer.
Instructions on safely removing shipping bolts from the new washer.
Steps for adjusting the washer's leveling feet to ensure stability and proper operation.
Detailed instructions for connecting the water supply hoses correctly.
Guidance on properly connecting the drain hose to a standpipe or laundry tub.
Instructions to remove protective film from the inside of the washer door before use.
Steps to connect the power cord and turn on the washing machine.
Covers initial settings, including the recommended drum calibration process.
Provides guidance on sorting laundry, emptying pockets, and preparing items for washing.
Details using laundry nets, determining load capacity, and selecting the correct detergent type.
Explains the detergent dispenser compartments and usage for main wash, softener, and bleach.
Step-by-step guide for adding liquid and powdered detergents, and fabric softener to the dispenser.
Instructions for using powdered detergent, bleach, and oxygen boosters correctly.
Explains the functions of each button and dial on the washer's control panel.
Clarifies the meaning of various icons displayed on the control panel.
A quick guide to starting a wash cycle, including changing settings and starting the machine.
Describes the standard wash cycles available on the washer.
Details the specialized steam cycles and their applications.
A chart to help select the best cycle and options for different types of laundry.
Explains advanced features like Delay End, ATC, Child Lock, Alarm Off, Downloaded cycles, and SmartThings connectivity.
Instructions for running the Self Clean+ cycle to keep the drum fresh and clean.
How to use the Smart Care function for self-diagnosis and troubleshooting.
Steps to follow to drain water from the washer in case of a power failure.
Guidance on cleaning the exterior surface and the mesh filter of the water inlet hoses.
Instructions for cleaning the pump filter to prevent clogs and ensure proper operation.
Steps for removing and cleaning the detergent drawer and its components.
How to clean the door diaphragm and recover the washer from freezing conditions.
Advice for storing the washer long-term and cleaning its exterior surfaces.
Guidelines for cleaning the interior of the washer to remove residue, odors, and bacteria.
A table listing common washer problems and their corresponding troubleshooting actions.
Explains various error codes displayed on the washer and how to resolve them.
A chart detailing care symbols for washing, bleaching, drying, and ironing clothes.
Information on environmental impact, recyclability, and product compliance statements.
Lists detailed technical specifications of the washing machine, including dimensions and power ratings.
Details the warranty period, coverage, and how to obtain service for the Samsung washer.
Lists specific situations and damages not covered by the warranty and limitations on remedies.
Defines the exclusive remedies available under warranty and provides contact information for service.
To Next Page
General