EasyManua.ls Logo

Samsung WW10H9 Series - Water Temperature; Alcove or Closet Installation

Samsung WW10H9 Series
280 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English - 13
INSTALLATION
Drain
Samsung recommends a standpipe in height of 65 cm. The drain hose must be connected through
the hose clip to the standpipe, and the standpipe must fully cover the drain hose.
Flooring
For best performance, the washing machine must be installed on a solid floor. Wood floors may
need to be reinforced to minimize vibration and/or unbalanced loads. Carpeting and soft tile
surfaces are not a good resistance to vibrations and may cause the washing machine to move
slightly during the spin cycle.
CAUTION
Do NOT install the washing machine on a platform or a poorly supported structure.
Water temperature
Do not install the washing machine in areas where water may freeze as the washing machine
always retains some water in its water valves, pumps, and/or hoses. Frozen water left in the
connection parts may cause damage to belts, the pump, and other components of the washing
machine.
Alcove or closet installation
Minimum clearance for stable operation:
Sides 25 mm Rear 50 mm
Top 25 mm Front 550 mm
If both the washing machine and a dryer are installed in the same location, the front of the alcove or
closet must have at least a 550 mm unobstructed air opening. Your washing machine alone does
not require a specific air opening.
Untitled-1 13 2015-01-26  11:47:11

Table of Contents

Related product manuals