61
Sending box setting
Enter `Screen Config`, choose `Sending Board` as shown in Fig 9-6.
Fig 9-6
In this interface, the user can set up `Sending Board`, `Scan Board` and `Screen
Connection `
Attention: Usually the resolution of transmitting card is bigger than the resolution of the
LED display screen. Fox example, the resolution of the LED display screen is 1400*720,
the user can not choose 1280*1024, must choose bigger than 1400*900.
Another notice: Every RJ-45 output of transmitting card can offer 650,000 pixels, if your
LED display`s pixels are more than this, you must use 2 cat-5 cable or more.
To Next Page
Loading...
