Transport and
installation
The equipment must be firmly fixed during transport and
installation. Otherwise, there will be a danger of tipping or
falling.
The power cable terminal must be equipped with the electric
leakage and overload protection device according to the rated
current indicated on the equipment nameplate.
Stop running in
abnormal state
When the equipment is abnormal, do not start the machine
at this time, until the reason for the abnormal is known and
there is no risk when starting the machine.
Do not put fingers or
other things into the gap
of the equipment
There are rotating parts inside the device. Do not put fingers
or other things into the gap of the equipment.
a)
When the refrigerant leaks, please make sure that the
ventilation is available.
b)
Avoid contacting with skin.
Transportation with
liquid is prohibited
The equipment is not allowed to be transported with liquid to
prevent internal pipeline leakage.
a)
The equipment should be fixed firmly before transportation
to prevent the equipment from moving due to vibration and
external forces. If there is excessive vibration and external
force, the internal equipment may be damaged.
b)
Tilt angle should be ≤45°.Otherwise, the refrigeration
system will fail.
a)
It is forbidden to use in special environments such as high
temperature, humidity, strong electromagnetic interference,
etc.
b)
The equipment must be installed in a place where there is
no direct sunlight and away from the fire sources.
a)
The equipment must be installed on a horizontal surface.
Otherwise, the refrigeration system will fail;
b)
It is forbidden to place objects within 1 meter around the
air inlet and 1.5 meters around the air outlet. If the air inlet
and the air outlet are blocked, the cooling ability that the
equipment should have cannot be realized.
To Next Page
Loading...
