S&C IntelliRupter PulseCloser Installation

22 S&C Instruction Sheet 766-510
Operation
Status Indicator
The STATUS INDICATOR (white LED) light shows
operational status of the IntelliRupter fault interrupter.
See Figure 33.
Off:
• IntelliRupter fault interrupter is not powered
• IntelliRupter fault interrupter is not functioning
properly
Solid On:
• If con gured by user, Remote Operation mode is
disabled
Flashes for ½ second every 30 seconds:
• Normal operation
On 10 seconds, then flashes for ½ second every
30 seconds:
• Wi-Fi has been disconnected
• Interrupter OPEN/CLOSE/READY lever has been
moved from:
– Ready to Open
– Ready to Close
– Open to Ready
• GROUND TRIP BLOCK lever has been moved from:
– Removed to Set
– Set to Removed
Pulsates dim to bright:
• Wi-Fi is connected
Flashes for ½ second every second:
• Any error state is active
• Settings Mismatch is active and, if con gured by
user, Battery Low, Bad or Disconnected
Flashes 3 times (½ second on, ½ second off) every
30seconds:
• IntelliTeam® SG Automatic Restoration System is
in the Ready state
• Or Loop Restoration is in the Ready state
Hot Line Tag Indicator
The HOT LINE TAG indicator (amber LED) shows status
of hot line tags.
Off:
• All hot line tags have been removed
Flashes for ½ second every 2 seconds:
• Hot line tag has been applied
Figure 33. HOT LINE TAG and STATUS indicators are located
on the face of the protection and control module.

S&C IntelliRupter PulseCloser Specifications

General

Brand	S&C
Model	IntelliRupter PulseCloser
Category	Industrial Electrical
Language	English