17
Operating your digital receiver – Search tuning FM
1. Press the Standby button to switch on your digital receiver.
2. Press the Band button as needed until the AM band is selected.
3. Press and release the Auto-tune button to carry out an auto-tune. Your digital receiver will scan
up the AM band from the currently displayed frequency and will stop scanning automatically
when it nds a station of sufcient strength. To scan down the AM band, press and hold the
Auto-tune button.
4. To nd more AM stations press and release the Auto-tune button to repeat the scan operation
as DAB stations before.
5. When the end of the waveband is reached your digital receiver will recommence tuning from
the opposite end of the waveband.
6. Use the Volume control to adjust the sound level as required.
To Next Page
