9
Operating your digital receiver – DAB
1. Press the Standby button to switch on the digital receiver. If the digital receiver has been used
before the last used mode will be selected.
2. Press and release the Band button as needed so that DAB mode is selected on the display.
3. If this is the rst time the digital receiver is used a full scan of the DAB channels in your country
will be carried out. The display will show “DAB” for a few seconds. (If the digital receiver has
been used before the last used station will be selected).
4. The rst station in the list of stations found during the scanning process will be played. The
display will show the station name.
5. If no signals are found, the digital receiver will show “OFF AIR” and it may be necessary to
relocate your digital receiver to a position giving better reception, and then repeat the scan
following above procedure.
To Next Page
Loading...
