SANKI MFC-S3B-F - Page 23

21 / 32
20.
A
n
20.0
20.0
20.0
0A0.0
SAVE
09 3 20.0
n
09 3
A
09 2
20.
09 2
⑥-B Adjustment of the feedback amplification rate
Press the Vol▼ key
8 times.
Set key
Freq▲▼ keys
Press the
Func key long
for 2 sec.
Set key
Func key
Freq▲▼ keys
Func key
Freq▲▼ keys
Set key
The operation described in this section is
performed
if the feedback control fails
(the
parts
feeding speed varies according to
the
parts
quantity).
This
operation raises/lowers the
amplification
rate
of the vibration sensor signal input.
Press the
Func key long
for 2 sec.
※Press the ON/OFF
key to turn OFF the
RUN lamp (stop status).
If the stop status is not
realized, the parameter
No. 09 cannot be
changed even if the Set
button is pressed.
ON/OFF key
ON/OFF key
Press the
Set key long
for 2 sec.
※Press the Set key
long for saving.
※Press the ON/OFF
key to brink the RUN
lamp (operation status).
Blinking
Blinking
Blinking