SANKI MFC-S3B-F - Page 28

26 / 32
12. Parameter Setting Method
1) Parameter data setting method
0.0
0A0.0 0b0.0 0C0.2 0d--
0E0.0 0F0.0 0n30 0LoF
0P10 06Lo 07hi 08AL
09 3 00-- PAL1 0.0
180.0 U100 io01 0u 0
0A 0.0
0A 1.5
0A1.5
0.0
Press the
Func key long
for 2 sec.
Set key
Freq▲▼ keys
Set key
Normal mode screen
Blinking
Blinking
Vol▲▼ keys
Press the
Func key long
for 2 sec.
Parameter mode
screen
The normal mode
screen appears.
※ When the Set key is pressed after value setting,
the set value is saved.
※ If the Vol▲▼ keys are pressed without pressing
the Set key in the change process, the changes will
not be saved but cancelled.
If there is no key operation for over 5 min, the
normal mode screen (voltage display) will be forced
to reappear.
※When the Set key is pressed at the parameter
to be set, the parameter item blinks, and the
parameter value can be changed. Here,
Parameter No. 0A is exemplified.
*
*
*
*
*
*
*
*
※When the Vol▲▼ keys are pressed in the parameter mode,
the display of the parameter items shown within the following
frame can be switched:
Vol▲ key: Switching 0A → 0b → 0C… in this order
Vol▼ key: Switching 0A → 0u → io01… in this order
※In the A mode, only the parameters marked with “＊” can be
changed.
In the n mode, all parameters can be changed.
For details, refer to the table of “Parameter Settings.”