What to do if no water is delivered from the group in my Sanremo Coffee Maker?
If no water is coming from the group, the mains water or purifying filter taps might be closed; make sure to open them. Also, the filter on the water intake coupling could be clogged; in this case, remove and clean it. Check regeneration of the water purifying filter. For a clogged gigleur, call technical assistance.
Why is the boiler fill level display flashing on my Sanremo Coffee Maker?
A flashing boiler fill level display can indicate several issues. First, check if the mains water or purifying filter taps are closed and open them if necessary. It could also be due to a boiler fill malfunction; in that case, turn off the power for at least 5 seconds, then turn it back on using the ON/OFF button. If these steps don't resolve the issue, call technical assistance.
What to do if insufficient coffee is used in Sanremo Coffee Maker?
If insufficient coffee is being used, it might be because the ground coffee is either too fine or too coarse. Check the grinding time and adjust the grinding coarseness accordingly. If the shower screen and filters are partially clogged, call technical assistance.
Provides essential safety guidelines for operating and maintaining the machine.
How to reset the safety thermostat for the service boiler.
Procedure to reset the safety thermostat for the small boiler.
Steps for resetting the unit's safety thermostat.
Guide to replace the heating element of the cup heating plate.
Instructions for replacing the probe on the cup heating plate.
Procedure for replacing the heating element of the boiler.
Steps to replace the thermostat in the boiler.
Guide to replace the unit boiler.
Procedure for replacing the heating element of the coffee boiler.
Instructions for removing and replacing the water pump.
Steps to replace the motor component of the pump.
Procedure for replacing the solenoid valve for boiler filling.
Instructions for replacing the mixed water solenoid valve.
Steps to replace the hot water solenoid valve.
Procedure for replacing the cooling cycle solenoid valve.
Guide to replace the purge solenoid valve.
Steps to replace the pre-infusion solenoid valve.
Procedure for replacing the unit solenoid valve.
Instructions for safely removing the service boiler.
Guide to remove and replace the group head and its gaskets.
General| Boiler Type | Heat Exchanger |
|---|---|
| Pump Type | Rotary |
| Display | Digital |
| Body Material | Stainless Steel |
| Pressure Control | Yes |
| Temperature Control | PID |
| Steam Wand | Yes |
| Type | Semi-Automatic |
| Boiler Material | Copper |
| Material | Stainless Steel |
| Voltage | 230 V |
| Features | Pre-infusion |
| Water Tank Capacity | No water tank, direct water line connection required |
| Groups | 2 |
To Next Page
