Adjusting water mix for hot water tap
Water mix valve located near water pipe connection
Group Volumetric Programming
• Press and hold Sanremo logo (continuous) button on group 1 (left most group) until touchpad LED’s
begin flash and pressure display reads ‘DOSES SETTING SELECT DOSE IN 30 S’.
• Insert coffee prepped portafilter into group and select dose button for programming.
• When desired volumetric dose has been reached, press the same dose button to store volumetric
program.
• Repeat steps 2 & 3 for remaining dose buttons.
• Follow same procedure to program hot water tap dispensing volume.
• When finished, do not touch any of the group buttons for 30 seconds. Machine will then store program
and transfer to the remaining groups.
To Next Page
Loading...
