Need help?Do you have a question about the Sansui 2000A and is the answer not in the manual?
General| Power Output | 35 watts per channel into 8Ω (stereo) |
|---|---|
| Total Harmonic Distortion | 0.8% |
| Speaker Impedance | 4Ω to 16Ω |
| Frequency Response | 20Hz to 20kHz |
| Input Sensitivity | 2.5mV (MM) |
| Signal to Noise Ratio | 70dB (MM) |
| Output | Headphones |
| Semiconductors | transistors, diodes |
Procedure for disassembling the front panel, bonnet, and bottom plate.
Steps for removing the wood case from the unit.
Diagram illustrating the dial mechanism components.
Identifies and labels various test points on the circuit boards.
Step-by-step guide for aligning the FM section of the tuner.
Procedure for aligning the FM multiplex stereo circuit.
Step-by-step guide for aligning the AM section of the tuner.
List of components and their locations for the F-1222 Tone Control Block.
List of components and their locations for the F-1253 Equalizer Amp. Block.
List of components and their locations for the F-1197 Rectifier Block.
List of components and their locations for the F-1195 Ripple Filter Block.
List of components and their locations for the F-1224 Noise Canceler and Muting Block.
List of components and their locations for the F-1223 High-Low Filter Block.
List of components and their locations for the F-1220 AM Meter Block.
List of components and their locations for the F-1254 Accessories Block.
List of components and their locations for the F-1214 FM IF Block.
List of components and their locations for the F-1190 Multiplex Block.
List of components and their locations for the F-10381 AM IF Block.
List of components and their locations for the F-1180 Driver Amp. Block.
Details on modifying the power circuit to address noise issues.
Procedure to address hum on PHONO 1 or 2 inputs by adding a ripple filter.
To Next Page
