Sansui 6060 - 4. THREADING OF DIAL CORD; 4-1. Threading of Dial Cord; 4-2. Attachment of Dial Pointer

4. THREADING OF DIAL CORD
*If a dial cord is cut off or slips, replace it by following procedures.
As
this
unit
uses
0.6mmé¢
cord,
please
replace
it
with
the
same
type
certainly.
*The length of dial cord is approximately 160cm (65.3 inch).
FM
‘AM’ 535. 600
Fig. 4-2
4-1. Threading of Dial Cord
Thread the dial cord in numerical order from @® to
as Fig. 4-1. Seen ras:
1) Close the variable capacitor completely (Max. capa-
citance).
2) Tie dial cord to the screw S1 of the dial pulley.
3) Thread cord in the direction of arrow from @ to @.
4) After @, tie the cord to the screw $2 of the dial
pulley.
4-2. Attachment of Dial Pointer
1) Close the variable capacitor completely.
2) Set the.dial pointer as Fig. 4-2. —
*Confirm that the dial pointer runs smoothly on the
dial scale by turning the tuning shaft.
Parts List
Stock No. Description
6036050 Dial Cord (0.6mm¢)
6146663
D35 Type Pulley