Need help?Do you have a question about the Sansui 661 and is the answer not in the manual?
General| Power Output | 20 watts per channel into 8Ω (stereo) |
|---|---|
| Total Harmonic Distortion | 0.8% |
| Tuning Range | FM, MW |
| Damping Factor | 30 |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Speaker Load Impedance | 4Ω to 16Ω |
| Channel Separation | 45dB |
Detailed specifications for the audio output, distortion, and frequency response.
Technical specifications for FM and AM tuning, sensitivity, and selectivity.
Illustrates the functional blocks and signal paths within the receiver.
Depicts signal voltage levels at various stages of the receiver.
Procedures for adjusting bias current and DC offset on the driver circuit board.
Steps to align the FM intermediate frequency (IF) coils for optimal reception.
Procedures for calibrating the FM dial and aligning the radio frequency stage.
Identifies symptoms and causes for power supply failures and no-power conditions.
Guides on troubleshooting audio output problems, bias current, and center voltage.
Covers troubleshooting for both FM and AM tuner sections, including signal meter and muting.
Lists components and their locations on the pre-amplifier circuit board.
Lists components and their locations on the tuner circuit board.
Lists components and their locations on the driver circuit board.
Lists components and their locations on the power circuit board.
Instructions for setting the unit's voltage selector for different power supplies.
To Next Page
