Need help?Do you have a question about the Sansui R-5 and is the answer not in the manual?
General| Frequency response | 20Hz to 20kHz |
|---|---|
| Speaker load impedance | 8Ω to 16Ω |
| Input sensitivity | 2.5mV (MM), 150mV (line) |
| Signal to noise ratio | 75dB (MM), 95dB (line) |
| Tuning range | FM: 88-108 MHz, AM: 530-1605 kHz |
| Channel separation | 50dB (line) |
Detailed specifications for audio performance, including power output and distortion.
Detailed specifications for FM reception, including sensitivity and distortion.
Detailed specifications for AM/MW/LW reception, including sensitivity and tuning range.
Step-by-step guide for adjusting FM IF, RF, and dial calibration for optimal performance.
Procedures for adjusting FM stereo reception, including muting and VCO settings.
Adjustments for AM IF coils and calibration of the MW dial pointer.
Procedure for calibrating the LW dial pointer on the R-5L model.
Identification of front panel controls and indicators for the R-5 model.
Identification of internal components and external terminals for the R-5 model.
Detailed schematic diagram for the Sansui R-5 receiver.
Detailed schematic diagram for the Sansui R-5L receiver.
To Next Page
