Need help?Do you have a question about the Sansui AU-717 and is the answer not in the manual?
General| Power Output | 85 watts per channel into 8Ω (stereo) |
|---|---|
| Total Harmonic Distortion | 0.025% |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Speaker Load Impedance | 8Ω to 16Ω |
| Signal to Noise Ratio | 100dB (line) |
| Dimensions | 430 x 168 x 453mm |
| Channel Separation | 60dB |
| Output | Pre out |
Details on power output, load impedance, and frequency response bandwidth.
Specifications for harmonic/intermodulation distortion, frequency response, RIAA, and damping factor.
Input sensitivity, impedance, output levels, and channel separation characteristics.
High-level functional block diagram illustrating major circuit sections and signal flow.
Step-by-step guide for adjusting driver circuit board parameters.
Schematic diagram for the AU-517 power supply section.
Schematic diagram for the AU-717 power supply section.
Explanation of the protector circuit's function for DC voltage at the output.
Explanation of the protector circuit's function against excessive current.
To Next Page
