Need help?Do you have a question about the Sansui G-2000 and is the answer not in the manual?
General| Power Output | 20 watts per channel into 8Ω (stereo) |
|---|---|
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Frequency Response | 20Hz to 20kHz |
| Signal to Noise Ratio | 90dB (line) |
| Tuning Range | FM 88 to 108 MHz, MW 530 to 1600 kHz |
| Speaker load impedance | 4Ω to 16Ω |
Steps for FM IF coil, dial calibration, and signal meter adjustment.
Procedures for adjusting FM stereo VCO and separation.
Complete schematic diagram for the Sansui G-2000 receiver.
Complete schematic diagram for the Sansui G-3000 receiver.
To Next Page
